Sun Microsystems Sun Fire X4100 - Page 64

2-36 Sun Fire X4100/X4100 M2 and X4200/X4200 M2 Servers Service Manual • August 2009
Sun Fire X4100 M2/X4200 M2 Servers
Main Advanced PCIPnP Boot Security Chipset Exit
********************************************************************************
* Advanced PCI/PnP Settings ** NO: lets the BIOS *
* ***************************************************** configure all the *
* WARNING: Setting wrong values in below sections ** devices in the system. *
* may cause system to malfunction. ** *
* ** YES: lets the *
* Clear NVRAM [No] ** operating system *
* Plug & Play O/S [No] ** configure Plug and *
* PCI Latency Timer [64] ** Play (PnP) devices not *
* Allocate IRQ to PCI VGA [Yes] ** required for boot if *
* Palette Snooping [Disabled] ** your system has a Plug *
* PCI IDE BusMaster [Disabled] ** and Play operating *
* OffBoard PCI/ISA IDE Card [Auto] ** system. *
* PCI Option ROM control [Enabled] ** *
* Scanning onboard SAS/SATA ROM [Enabled] ** *
* Scanning onboard NIC OPROM [Enabled] ** ** Select Screen *
* Scanning OPROM on PCIE SLOT0 [Enabled] ** ** Select Item *
* Scanning OPROM on PCIE SLOT1 [Enabled] ** +- Change Option *
* Scanning OPROM on PCIX SLOT2 [Enabled] ** F1 General Help *
* Scanning OPROM on PCIE SLOT3 [Enabled] ** F10 Save and Exit *
* Scanning OPROM on PCIE SLOT4 [Enabled] ** ESC Exit *
* Onboard PCI NIC MAC Address ** *
* Nvidia CK804 NIC 1 : 00 03 BA CD 51 39 ** *
* Nvidia IO4 NIC 2 : 00 03 BA CD 51 38 ** Available: Specified *
* Intel GiGE NIC 3 : 00 03 BA CD 51 3B ** DMA is available to be *
* Intel GiGE NIC 3 : 00 03 BA CD 51 3B ** used by PCI/PnP *
* ** devices. *
* IRQ3 [Available] ** Reserved: Specified *
* IRQ4 [Reserved] ** DMA is reserved for *
* IRQ5 [Available] ** use by legacy ISA *
* IRQ7 [Available] ** devices. *
* IRQ9 [Available] ** *
* IRQ10 [Available] ** *
* IRQ11 [Available] ** *
* IRQ14 [Available] ** *
* IRQ15 [Available] ** ** Select Screen *
* ** ** Select Item *
* DMA Channel 0 [Available] ** +- Change Option *
* DMA Channel 1 [Available] ** F1 General Help *
* DMA Channel 3 [Available] ** F10 Save and Exit *
* DMA Channel 5 [Available] ** ESC Exit *
* DMA Channel 6 [Available] ** *
* DMA Channel 7 [Available] ** *
* ** *
* Reserved Memory Size [Disabled] ** *
********************************************************************************