POWER TRIM AND TILT 9-5
Remove the PTT cylinder lower shaft bolts 6.
Slide the STBD clamp bracket 8 fully outward to the right hand
side.
Remove the PTT unit 9 from between the clamp brackets.
PTT MOTOR
REMOVAL
NOTE:
Before removing PTT motor, wash the PTT body with a stiff
bristle brush and hot, soapy water to remove sand or dirt and
dry the PTT body with compressed air .
Unscrew the fill plug and drain PTT oil into suitable container .
Place the lower mounting eye of the PTT cylinder in a vise.
Tighten the vise only enough to secure the PTT unit, do not
over tighten.
NOTE:
To prevent damage to the PTT cylinder use wood blocks, vise
jaw protectors, etc., between the vise jaws and PTT compo-
nents before tightening vise.
To Next Page
Loading...
