FUEL SYSTEM 5-5
7. Remove the four (4) bolts 6 and two (2) nuts securing inlet
case 7 to intake manifold.
11. Loosen the carburetor flange nuts A and remove them.
Remove the plates B, air silencer pipe 3, carburetors 8
and insulators from inlet case 7, and then discard the car-
buretor gaskets.
8. Remove three (3) carburetors 8 with inlet case, then re-
move the fuel inlet hose from the bottom 3-way joint.
9. Remove four (4) screws and silencer case 2.
10. Take off the choke and throttle link rods 9
.
0 from each
carburetor.
Remove the bolts and choke solenoid C. (R / T models)
Remove the bolts and carburetor protector C. (Tiller handle
model.)
To Next Page
Loading...
