Suzuki DL650K5 - Page 139

ENGINE 3-85
GEAR POSITION SWITCH
• Install the gear position switch contacts

1 and springs.
• Apply SUZUKI SUPER GREASE to the O-ring

2 and then
install it onto the gear position switch.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the gear position switch

3 as shown.
• Tighten the gear position switch bolt to the specified torque.
$ Gear position switch bolt: 6.5 N·m (0.65 kgf-m, 4.7 lb-ft)
• Install the drive shaft oil seal retainer

4.
NOTE:
Pass through the gear position switch lead wire under the drive-
shaft oil seal retainer.
FRONT CAM CHAIN
• Install the front cam chain

1.
• Install the cam chain tensioner

2, washer

3 and cam chain
tensioner bolt

4.
• Tighten the cam chain tensioner bolt

4 to the specified
torque.
$ Cam chain tensioner bolt: 10 N·m (1.0 kgf-m, 7.0 lb-f)
NOTE:
The front and rear cam chain tensioners are the same.
PartShark.com
877-999-5686