ENGINE 3-107
EXHAUST PIPE
• Tighten the exhaust pipe bolts
1 to the specified torque.
$ Exhaust pipe bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
#
WATER UNION
• Install the O-ring to the water union.
#
• When installing the water union, apply engine coolant to the
O-ring.
/ ENGINE COOLANT
INTAKE PIPE
• Apply SUZUKI SUPER GREASE to the O-ring.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
#
• Make sure that the “UP” mark
A faces upward.
• Install the intake pipes.
NOTE:
The intake pipe can be identified by the mark
B
.
F: Front cylinder head intake pipe
R: Rear cylinder head intake pipe
Use the new gasket to prevent exhaust gas leakage.
Replace the O-ring with a new one.
Use the new O-ring to prevent air from sucking
through the joint.
PartShark.com
877-999-5686
To Next Page
Loading...
