CHASSIS 7-33
• Set the punch mark
C on the handlebar clamp forward.
• Tighten the handlebar clamp bolts to the specified torque.
! Handlebar clamp bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
NOTE:
When tightening the handlebar clamp bolts, first tighten the bolt
1
and then tighten the bolt
2
.
HANDLEBAR SWITCH BOX
• Install the throttle cable case.
• Apply SUZUKI SUPER GREASE to the throttle cables and
their holes.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Align the mating surface
B of the throttle case with the punch
mark
A on the handlebars.
• Install the right handlebar switch box to the handlebars by
engaging the stopper
1 with the handlebar’s hole
2.
• Install the front brake master cylinder. ("7-67)
• Install the handlebars with the punch mark
C aligned with the
mating surface
D of the clutch lever holder.
PartShark.com
877-999-5686
To Next Page
Loading...
