COOLING SYSTEM HOSE ROUTING
1 Clamp *4
Clamp the water drain hose and oil pressure switch lead
wire.
2 Wiring harness *5
Fill the bearing with engine oil until engine oil comes out
from the hole of the be bearing housing.
3 Oil pressure switch *6 Clamp bolt head upward.
4 Oil filter *7 Clamp bolt head downward.
*1 Clamp end downward. *8
Pass through the reservoir overflow hose between the
brake pipe and reservoir inlet hose.
*2 Matching mark (White) *9
Pass through the reservoir inlet hose left side of high
tension cord and right side of harness (for IAP sensor).
*3 Matching mark (Blue)
*6
*1
*6
*8
*7
*7
*9
*2
*3
*4
*5
DL650K7/AK7 (’07-MODEL) 13-137
PartShark.com
877-999-5686
To Next Page
Loading...
