3-34 ENGINE
• Remove the O-ring
3.
• Remove the switch contacts
4 and springs
5.
CRANKCASE
• Remove the oil plate
1.
• Remove the crankcase bolts and clamp
2.
NOTE:
Loosen the crankcase bolts diagonally and smaller sizes first.
• Separate the crankcase into 2 parts, right and left with the
special tool.
" 09920-13120: Crankcase separating tool
NOTE:
* Fit the crankcase separating tool, so that the tool arms are in
parallel with the side of crankcase.
* The crankshaft and transmission components should remain
in the left crankcase half.
PartShark.com
877-999-5686
To Next Page
Loading...
