ENGINE 3-75
Turn the crankshaft until the TDC line
E on the generator
rotor aligns with the index mark
F on the crankcase.
CYLINDER HEAD COVER
Clean the mating surface of the cylinder head and head cover
before matching.
Install the dowel pins to the cylinder head.
Apply SUZUKI BOND to the periphery of the camshaft end
cap
1 and fit it
99000-31230: SUZUKI BOND 1216B
Apply SUZUKI BOND to the mating surface of the cylinder
head cover.
99000-31230: SUZUKI BOND 1216B
Tighten the cylinder head cover bolts to the specified torque.
" Cylinder head cover bolt: 10 N•m (1.0 kgf-m, 7.0 lb-ft)
'
CAM CHAIN TENSION ADJUSTER
After removing the spring holder bolt and spring, unlock the
ratchet mechanism
1 and push in the push rod
2 all the way.
NOTE:
Before installing the cam chain tension adjuster, unlock the
ratchet mechanism
1 and move the push rod
2 in place to see
if it slides smoothly.
1216
1216
1216
1216
Fit the washer to the bolt
A.
PartShark.com
877-999-5686
To Next Page
Loading...
