Suzuki LT-Z250 - Page 124

4-6 DRIVE TRAIN
 Remove the bearing with the special tool.
" 09913-70210: Bearing installer set
NOTE:
If there is no abnormal condition, the bearing removal is not nec-
essary.
#
 Remove the pinion gear shaft coupling joint with the special
tools.
" 09923-74510: Bearing remover
09930-30104: Sliding shaft
 Remove the oil seal with a suitable tool.
NOTE:
If there is no abnormal condition, the oil seal removal is not nec-
essary.
#
 Unstake the bearing locknut with a small chisel or drill.
 Remove the bearing locknut with the special tool.
" 09921-21820: Bearing locknut wrench
#
The removed bearing must be replaced with a new
one.
The removed oil seal must be replaced with a new one.
Replace the bearing locknut with a new one.
PartShark.com
877-999-5686