DRIVE TRAIN 4-13
BEVEL PINION GEAR SHAFT BEARING
Drive the bearing onto the shaft with the special tool.
" 09913-70210: Bearing installer set
BEVEL PINION GEAR/SHIM/LOCKNUT
[FINAL ASSEMBLY]
Install new O-ring
1 onto the pinion gear shaft.
Install the shim, pinion gear assembly and new bearing
locknut.
Tighten new bearing locknut to the specified torque.
" 09921-21820: Bearing locknut wrench
% Bearing locknut: 100 N•m (10.0 kgf-m, 72.5 lb-ft)
NOTE:
After the backlash and tooth contact have been checked or
adjusted (!4-18), stake the nut with a center punch.
PartShark.com
877-999-5686
To Next Page
Loading...
