3-32 ENGINE
• Apply MOLYBDENUM OIL SOLUTION to the inside of the
drive shaft journal.
MOLYBDENUM OIL SOLUTION
• Install the washer 2 to the drive shaft.
• Install the drive shaft 3 to the CVT case.
• Install the washer 4 and 5.
• Install the dowel pins 6.
• Apply SUZUKI BOND “1215” to the final reduction gear box
cover matching surface.
99000-31110: SUZUKI BOND “1215” or equivalent
NOTE:
* Make surfaces free from moisture, oil, dust and other foreign
materials.
* Spread on surfaces thinly to from an even layer, and assemble
the cover within few minutes.
• Tighten the final reduction gear box cover bolts and drain plug
7 to the specified torque.
Final reduction gear box cover bolt:
11 N·m (1.1 kgf-m, 8.0 lb-ft)
NOTE:
Tighten the drain plug 7 together with the new gasket.
Apply final reduction gear box oil to the gears.
PartShark.com
877-999-5686
To Next Page
Loading...
