ENGINE 3-37
DAMPER INSPECTION
Inspect the dampers for wear or damage.
If any defects are found, replace the dampers with new ones.
REASSEMBLY
• Position the rollers 1 on the movable drive face 2.
• Mount the dampers 3 on the movable drive face plate 4.
• Check that the rollers 1 are in normal position in the movable
drive face 2.
• Position the movable drive face plate 4 on the movable drive
face 2.
CLUTCH SHOE/MOVABLE DRIVEN FACE DISASSEMBLY
• Hold the clutch shoe assembly 1 with the special tool.
09930-40113: Rotor holder
• Loosen the clutch shoe nut 2.
• Attach the special tool to the clutch shoe/movable driven face
assembly and compress the clutch shoe assembly by turning
in the special tool handle 2.
09922-31420: Clutch spring compressor
• Remove the clutch shoe nut 3.
Do not remove the clutch shoe nut before attaching
the clutch spring compressor.
Since a high spring force applies to the clutch shoe
assembly, care must be used so as not to cause the
clutch shoe assembly and movable driven face to
come off abruptly.
PartShark.com
877-999-5686
To Next Page
Loading...
