Suzuki LT-Z50 - Troubleshooting

ENGINE 3-45
REASSEMBLY
Reassemble the recoil starter in the reverse order of disassem-
bly. Pay attention to the following points:
• When installing the spiral spring, hook the spiral spring end 1
with the recoil starter case.

• Apply SUZUKI SUPER GREASE “A” to the spiral spring.

99000-25010: SUZUKI SUPER GREASE “A” or equivalent
• Turn the rope on the reel properly.
• After installing the spiral spring, engage the part A of the reel
with the spiral spring end 2.
• Hook the rope onto the hook part B of the reel.
• Turn the reel counterclockwise three or four times with the
rope.
• Lace the end of the rope through the recoil starter case hole
C.
• Tie a knot at the end of the rope.
• Install the cap 3 to the knob 4.
• Apply SUZUKI SUPER GREASE “A” to the sliding part of the
ratchet and reel.

99000-25010: SUZUKI SUPER GREASE “A” or equivalent
Wear hand and eye protection when installing the reel,
since the spiral spring may quickly unwind and cause
an injury.
PartShark.com
877-999-5686