Symantec NetBackup 5220 - Page 183

Table 12-12
Settings > Notification (continued)
Recommended actionExplanationError messages
Verify the configuration setting for the
SMTP server and try sending a test
email.
You may encounter this error when: A
test email cannot be sent using the
SMTP Server Configuration or the
SMTP server is temporarily
unreachable; although the
configuration details that are entered
for the SMTP server are correct.
Failed to send a test email. Please
verify that the SMTP server and the
email configuration are correct for this
appliance. Do you want to continue?
lists all the error messages, displayed on the Settings > Network tab.
Table 12-13
Settings > Network
Recommended actionExplanationError messages
VLAN ID is a unique identifier. Therefore,
provide a different vlan_id to tag the VLAN.
This message is displayed
when you try to tag a VLAN with
a vlan_id that already exists.
Failed to create VLAN. <vlan_id>
already exists.
Specify an IP address that is not used by
other interfaces.
This message is displayed
when you try to tag VLAN with
an IP address that is already
configured for another interface.
Cannot tag VLAN <vlan_id>. The
specified IP address <ip> is already
configured. Specify an IP address that
is not in use.
Enter an valid subnet mask.This message is displayed if
you enter an invalid subnet
mask.
Invalid netmask <subnet_mask>.
Specify an IP address that is not used by
other interfaces.
This message is displayed
when you attempt to create a
bond with an IP address that is
configured for another interface.
Invalid IP address. IP address <ip> is
in use. Use Main->Network->Show
Status to verify.
Enter gateway information that corresponds
to your domain.
This message is displayed if
you enter gateway information
that is in another domain.
Failed to update routing information.
The network gateway is not reachable
with the route information that you
have provided. The gateway might not
be reachable because it is not covered
under a subnet mask that can be
reached through your network
interface settings.
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The current Fibre Transport
Settings for the appliance
cannot be displayed.
Error while retrieving Fibre Transport
Settings
183NetBackup Appliance error messages
Error messages displayed on the NetBackup Appliance Web Console