Symantec NetBackup 5220 - Page 184

Table 12-13
Settings > Network (continued)
Recommended actionExplanationError messages
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The Fibre Transport settings
cannot be enabled for your
appliance.
Error in enabling/disabling FT flag
configuration
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The SAN Client Fibre Transport
cannot be enabled for your
appliance.
Error in updating SAN client flag
configuration
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The current Fibre Transport
Settings for the appliance
cannot be displayed.
Load failed.
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
This message appears due to
an internal system error.
Error updating network optimization
status.
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
This message appears due to
an internal system error.
Error while retrieving WAN
optimization setting.
Table 12-14 lists all the error messages, displayed on the Settings > Date and
Time tab.
Table 12-14
Settings > Date and Time
Recommended actionExplanationError messages
Please ensure that the NTP server and
the web server are connected. If the
problem persists, collect the web GUI
and Perl logs all using the
DataCollect command and then
contact Symantec Technical Support.
This error can appear due to the
following reasons:
■ An internal system error has
occurred.
■ The connection to the NTP server
cannot be established.
■ The connection to the web server
is not established.
Unable to save the date and time
settings.
Please ensure that the provided IP
address for the NTP server is valid.
Also ensure that the NTP server is
connected to the appliance
This error appears if the NTP server
IP details are incorrect or the NTP
server is non-existent.
Unable to save the NTP server
settings. Check if the specified NTP
server exists.
Table 12-15 lists all the error messages, displayed on the Settings > Authentication
tab.
184NetBackup Appliance error messages
Error messages displayed on the NetBackup Appliance Web Console