EasyManuals Logo

Symmetricom TimeProvider 1000 User Manual

Symmetricom TimeProvider 1000
216 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #100 background imageLoading...
Page #100 background image
Chapter 4 Provisioning the TimeProvider
Provisioning the Input Reference
100 TimeProvider User’s Guide 097-58001-02 Revision C – August 2005
Autonomous Message
TP-SSU 03-10-24 10:44:21
A 1178 REPT EVT
“INP1,T1:NA,INSTATE,NSA,03-10-24 10-44-21:\"INPUT STATE
HAS CHANGED,MONITOR\””
;
Setting the GPS Parameters
After you install the GPS antenna, you must provision the parameters using the
ED-EQPT command.
ED-EQPT:[<tid>]:<aid>:[<ctag>]::<keyword>=<value>;
This command has a default access level of ADMIN.
Sample Command
ED-EQPT::GPS:TS1000::MODE=AUTO;
This command sets the GPS location mode to Automatic. The location of the GPS
antenna is determined from multiple satellite fixes.
<aid> <keyword> <value> Description Default value
GPS GPS input, except clock input
signals
MODE AUTO The antenna position (latitude,
longitude, and elevation) is
automatically computed or
recomputed and set
AUTO
MANUAL The position (latitude, longitude,
and elevation) is set manually using
the POS keyword
POS
Note: The
position can
only be set
when Mode
is MANUAL
LAT dd-mm-ss.ssN or
dd-mm-ss.ssS
n/a
LONG dd-mm-ss.ssE or
dd-mm-ss.ssW
ELEV hhhh.hh height in m
ELEVMASK 5 to 45 The elevation mask, below which
the TimeProvider will not track or
acquire a satellite
10

Table of Contents

Other manuals for Symmetricom TimeProvider 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 1000 and is the answer not in the manual?

Symmetricom TimeProvider 1000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 1000
CategoryClock
LanguageEnglish

Related product manuals