Symmetricom TimeProvider 1000 User Manual

097-58001-02 Revision C – August 2005 TimeProvider User’s Guide 121
Chapter 4 Provisioning the TimeProvider
Provisioning Alarms
This command allows alarms to automatically escalate to the next higher alarm
level after the time period specified in the FLTDELAY keyword has elapsed (see
Provisioning System-Level Alarms, on page 121, for more details).
Sample Command
SET-ATTR::SYS:TS1000::EXPFAIL=NA;
This command disables the Expansion Fail alarm that occurs if you are not using an
Expansion Panel with the TimeProvider.
Provisioning System-Level Alarms
You use the ED-SYNC command to provision system-level alarms. The CLRDELAY
and FLTDELAY parameters are system-wide; the parameters cannot be set for
individual alarms.
ED-SYNC:[<tid>]:<aid>:[<ctag>]::<keyword>=<value>;
This command has a default access level of ADMIN.
Sample Command
ED-SYNC::SYS:TS1000::CLRDELAY=5;
This command declares a faulted input to be valid five seconds after the alarm
condition has cleared.
<aid> <keyword> <value> Description Default value
SYS Access identifiers
CLRDELAY 0 to 1000 s Sets the time delay to
declare a valid input after
an alarm condition clears
10 s
FLTDELAY 1 to 15 s Sets the time delay before a
fault is declared due to
LOS, AIS, or OOF alarms
on the input
5 s
FREEFLT
ON | SQUELCH
| AIS
Determines the action
when the LO enters the
Free-Run mode
SQUELCH
HOLDFLT
ON | SQUELCH
| AIS
Determines the action
when the LO enters the
Holdover mode
ON

Symmetricom TimeProvider 1000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 1000
Category	Clock
Language	English