Symmetricom TimeProvider 1000 - Default Command Access Levels; Default Access Levels for TL1 Commands

To Next Page

To Previous Page

Appendix A Factory Default Values

Default Command Access Levels

198 TimeProvider User’s Guide 097-58001-02 Revision C – August 2005

Default Command Access Levels

This section describes the default access level for the TL1 commands described in

this guide. Table A-1 also describes whether you can edit the default command

access level using the ED-CMD-SECU command (see the TimeProvider TL1

Reference Guide for details on this command). For a complete list of commands

and their access levels, see the TimeProvider TL1 Reference Guide.

Table A-1. Default Access Levels for TL1 Commands

Command Default Access Level Editable?

RTRV-USER-SECU Security Yes

ENT-USR-SECU Security No

ED-USER-SECU Security No

ED-PID Security Yes

ENT-PID User Yes

DLT-SECU Security Yes

DLT-USR-SECU Security Yes

RTRV-CMD-SECU Admin Yes

ED-CMD-SECU Admin No

CPY-MEM Admin Yes

RTRV-DAT User Yes

ED-DAT Admin Yes

RTRV-EQPT User Yes

ED-EQPT Admin Yes

RTRV-SYNC User Yes

ED-SYNC Admin Yes

RTRV-ATTR User Yes

SET-ATTR Admin Yes

RTRV-LOG User Yes

INIT-LOG Admin Yes

INIT-SYS Admin Yes

RTRV-SYS-MODE User Yes

SET-SYS-MODE Admin Yes

OPR-ACO-ALL User Yes

Other manuals for Symmetricom TimeProvider 1000