Symmetricom TimeProvider 1000 User Manual

097-58001-02 Revision C – August 2005 TimeProvider User’s Guide 177
Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
Table 6-8 lists each event and describes the conditions that generate the associated
event.
<aid> = RTMg[-p]
S1LOS LOS on Side 1 T1 NSA IMMED NO MN MN MN
S2LOS LOS on Side 2 T1 NSA IMMED NO NA NA NA
EXSLIP Excessive slip rate T1 NSA IMMED NO NA NA NA
RTMFAULT The IOC cannot
determine if the Retimer
is functioning properly.
T1 NSA IMMED NO NA NA NA
Table 6-8. Event Code Conditional Descriptions
Event ID Event Conditional Description
IMC Event Conditions
ACCLVL User access level has changed
ACO Audio alarm is deactivated
ACCLVL User access level has changed
ACO Audio alarm is deactivated
ALMCHG Alarm parameter has changed, <keyword>,<alarm>
AOMERGE Autonomous event reporting has changed, <state>
BAUD Serial baud rate has changed, <value>
CMDCHG Command access level has changed, <command>
ECHO Serial port echo mode has changed, <state>
FLOW Serial flow control has changed, <state>
FWFAIL Firmware upgrade unsuccessful
FWOK Firmware upgrade successful
FWLOAD Beginning firmware upgrade
IMCBIST Built-in self test, <value>
INITLOG Event log has been cleared
IPADDR IP address has changed, <value>
Table 6-7. Alarms (Continued)
Alarm ID
Or
CONDTYPE
Alarm Condition
Description
AID
TYPE
Service
Affecting
Error
Delay
Default
Error
Delay
Editable
Alarm Default
Level
SSU PRS SUB

Symmetricom TimeProvider 1000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 1000
Category	Clock
Language	English