Chapter 4 Provisioning the TimeProvider
Saving Provisioning Data
132 TimeProvider User’s Guide 097-58001-02 Revision C – August 2005
Setting the System Mode, on page 96 System mode
Setting the IOC Parameters, on page 98 Oscillator type, IOC1
Oscillator type, IOC2
Setting the Input State, on page 99 Input mode, PRS
Input mode, INP1
Input mode, INP2
Input mode, GPS
Setting the GPS Parameters, on page 100 GPS Mode
GPS Position
GPS Elevmask
Setting the Input Frequency, on page 101 Frequency, PRS
Setting the Input Frame Type, on page
102
Frame type, INP1
Frame type, INP2
Controlling Automatic Reference
Switching, on page 102
Reference mode
Setting the Input Quality Level, on page
104
QLEVEL, PRS
QLEVEL, INP1
QLEVEL, INP2
QLEVEL, GPS
Setting the Input Priority Level, on page
105
PRIORITY, PRS
PRIORITY, INP1
PRIORITY, INP2
PRIORITY, GPS
Manually Selecting the Reference, on
page 105
INPREF
Provisioning the SSM, on page 106 SSMBIT, INP1
SSMBIT, INP2
Enabling CRC4, on page 108 CRCENA, INP1
CRCENA, INP2
Table 4-3. Provisioning Record (Continued)
Section Parameter User-Defined Value