097-58001-02 Revision C – August 2005 TimeProvider User’s Guide 163
Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
LOCTIM The local system time
offset has changed
EQPT (00)-00
(hh) – hours offset
±12
mm – minutes offset 00 to
59
REFMODE Indicates if the
system reference can
be selected
automatically or by
the user
EQPT AUTO AUTO – System uses
QLEVEL and Priority to
select the system reference
FORCED – User selects
the system reference. If the
selected reference fails,
this value reverts to AUTO
mode
TIMCHG The system time has
been changed
EQPT hh-mm-ss hh – hours (24-hour clock)
mm – minutes
ss – seconds
RTM Events
CKTIDCHG User modified the
Circuit ID for the
output.
T1 RTMg[-p] The Circuit ID can be up to
40 characters in length
FREEFLT Defines the Retimer
mode when the
system is in Free-run
mode.
T1 SQUELCH RETIME – In fault mode,
retime signals on Retimer
module
CUTTHRU – In fault mode,
Retimer module is in
cutthrough mode and
signals are not retimed
HOLDFLT Defines the Retimer
mode when the
system is in Holdover
mode.
T1 SQUELCH RETIME – In fault mode,
retime signals on Retimer
module
CUTTHRU – In fault mode,
Retimer module is in
cutthrough mode and
signals are not retimed
RTMLBO The specified
Retimer port Line
Build-Out has
changed.
T1 0 0 = 0 to 133 ft
1 = 133 to 266 ft
2 = 266 to 399 ft
3 = 399 to 533 ft
4 = 533 to 650 ft
Table 6-5. Event Codes (Continued)
Event ID
Keyword
Description
AID
TYPE
Default Value/
Keyword
Description of Values