Symmetricom TimeProvider 1000 User Manual

Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
172 TimeProvider User’s Guide 097-58001-02 Revision C – August 2005
MTIE Input has exceeded at
least one of the MTIE
alarm thresholds.
T1 NSA IMMED NO MN MN MN
TPIUSIG
TimeProvider Composite
Timing Signal interface is
not functioning
.
T1 NSA IMMED NO MN MN MN
<aid> = PRS
INPDISQ The specified input was
Disqualified or Qualified
as a possible system
reference. The fault
condition must be
continuously present for
the Fault Delay Time
(FLTDELAY) before
disqualifying the input
as a possible reference.
After INPDISQ is set,
the alarm clears when
the input signal is fault
free for the Clear Delay
Time (CLRDELAY).
T1 NSA FLT
DELAY
YES MN MN MN
INPLOS The specified input port
has Loss Of Signal.
When LOS is detected,
the input is immediately
removed from the
possible reference list.
The LOS must be
continuously present for
the Fault Delay Time
(FLTDELAY) before
disqualifying the input
as a possible reference.
After INPLOS is set, the
alarm clears when the
input signal is LOS free
for the Clear Delay Time
(CLRDELAY).
T1 NSA IMMEDNO MNMNMN
Table 6-7. Alarms (Continued)
Alarm ID
Or
CONDTYPE
Alarm Condition
Description
AID
TYPE
Service
Affecting
Error
Delay
Default
Error
Delay
Editable
Alarm Default
Level
SSU PRS SUB

Symmetricom TimeProvider 1000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 1000
Category	Clock
Language	English