27
83507013 Rev G
1.2.3 Features and Options
Constant Voltage / Constant Current with automatic crossover.
Active power factor correction.
Universal Input Voltage (85265Vac), continuous operation.
Embedded Microprocessor Controller.
Built-in RS232/RS485 Interface.
Voltage & Current high resolution adjustment by digital encoders.
High accuracy programming/readback.
Software Calibration (no internal trimmers / potentiometers).
Last Setting Memory.
Independent Remote ON/OFF (opto-isolated) and remote Enable/Disable.
Parallel operation (Master/Slave) with Active current sharing.
Remote sensing to compensate for voltage drop of power leads.
External Analog Programming and Monitoring standard (0-5V or 0-10V,
user selectable).
Cooling fan speed control for low noise and extended fan life.
Zero stacking-no ventilation holes at the top and bottom surface of the power supply.
Optional LAN and GPIB interface (SCPI compatible).
Optional Isolated Analog programming/monitoring (0-5V or 0-10V, user selectable
and 4-20mA).
1.2.4 Multiple Output Power System
The Genesys™ power supplies series can be configured into a programmable power
system of up to 31 units using the built-in RS232/RS485 communication port and the
RS485 linking cable provided with each power supply.
In a GPIB system, each power supply can be controlled using the optional GPIB
controller (factory installed).
1.2.5 Control via the Serial Communication Port
The following parameters can be programmed and monitored via the serial
communication port:
Output Voltage setting.
Output Current setting.
Output Voltage measurement.
Output On/Off control.
Output Current measurement.
Foldback protection setting
Over-voltage protection setting and readback.
Under-Voltage limit setting and readback.
Power-supply start up mode (Auto-restart or Safe-start mode).
To Next Page
Loading...
