TDK-Lambda GENESYS 750W - Accessories; Included Accessories; AC Cables; Hardware (Delivered with Power Supply)

29
83507013 Rev G
1.3 Accessories
1.3.1 Included Accessories
The following accessories are delivered with the power supply:
1.3.1.1 Serial Link Cable
Serial link cable for linking power supplies by RS485 communication.GEN/RJ45.
Cable description: 0.5m Length, shielded, RJ-45 type plugs, eight (8) contacts
(P/N 15507201)
1.3.1.2 Hardware (delivered with power supply)
 Output terminal Shield
 DB25 Programming Plug kit (AMP 749809-9)
 750W Only - Power Cord
 1500W Only – AC Input Strain Relief, Input Cover (no power cord)
1.3.2 Optional Communication Cables
 RS232 Cables to connect GEN to Serial Port on PC
 RS485 Cable to connect GEN to Serial Port on PC
GEN to PC(DB9)
GEN/485-9
P/N 15507202
1.3.3 AC cables
AC Cables are provided with 750W Model only, according to suffix in Model Number.
Part No.
Market
Description
NC301
(GEN/U)
USA
13A 125V, unshielded, 2m typical length, with IEC320 connector on one end and
NEMA-5-15P connector on the other end.
NC302
(GEN/E)
Europe
10A 250V, unshielded, 2m typical length, with IEC320 connector on one end and
INT’L 7 standard VII, dual earthing.
NC303
(GEN/O)
General
10A 250V, unshielded, 2m typical length, with IEC320 connector on one end and
unterminated stripped wires on the other end. Use the cable only with plug
approved by the national safety standards of the country of usage.
NC305
(GEN/J)
Japan
13A 125V, unshielded, 2m typical length, with IEC320 connector on one end and
Japan type plug on the other end.
NC306
(GEN/GB)
UK
10A 250V unshielded, 2m typical length, with IEC320 connector on one end and UK
type plug on the other end.
For 1500W Genesys
TM
power supplies the recommended AC cable (customer supplied) is:
25A 250V, 3x12AWG, outer diameter: 9-11mm, rated 60°C min., 3m max length.
Add a non-locking plug approved by the national safety standards of the country of
usage.
GEN to PC (DB9)
GEN 232/9
P/N 15507203
GEN to PC (DB25)
GEN 232/25
P/N 15507204