32
83507013 Rev G
NOTES:
*1. Minimum voltage is guaranteed to maximum 0.2% of the rated output voltage.
*2. Minimum current is guaranteed to maximum 0.4% of the rated output current.
*3. For cases where conformance to various safety standards (UL, IEC etc.) is required, to
be described as 100-240Vac (50/60Hz).
*4. At 100/200V input voltage and maximum output power.
*5. From 85~132Vac or 170~265Vac, constant load.
*6. From No-load to Full-load, constant input voltage. Measured at the sensing point in
Remote Sense.
*7. For load voltage change, equal to the unit voltage rating, constant input voltage.
*8. For 6V models the ripple is measured at 2~6V output voltage and full output current. For
other models, the ripple is measured at 10~100% output voltage and full output current.
*9. With rated, resistive load.
*10. For 6~300V models: Measured with JEITA RC-9131A (1:1) probe. For 600V model:
Measured with (10:1) probe.
2.12 Supplemental Characteristics
The supplemental characteristics give typical but non-warranted performance
characteristics. The supplemental characteristics are useful in assessing applications for
the power supply. Several kinds of supplemental characteristics are listed below.
1. Evaluation Data: Typical performance of the power supply.
2. Reliability Data: Reliability Performance of the power supply.
3. IEC1000 Data: Performance of the power supply under IEC1000 test conditions.
4. EMI Data: Typical EMI (conducted and radiated) performance of the power supply.
The supplemental characteristics data is held in each TDK-Lambda Americas Inc. sales and
service facility. For further details please contact the TDK-Lambda Americas Inc. office
nearest you.
To Next Page
Loading...
