TDK-Lambda GENESYS 750W - Page 9

5
83507013 Rev G
7.5.3 End of Message ___________________________________________________ 79
7.5.4 Command Repeat __________________________________________________ 79
7.5.5 Checksum ________________________________________________________ 79
7.5.6 Acknowledge ______________________________________________________ 79
7.5.7 Error message _____________________________________________________ 79
7.5.8 Backspace ________________________________________________________ 79
7.6 Error Messages ___________________________________________________________ 80
7.7 Command Set Description ___________________________________________________ 81
7.7.1 General Guide _____________________________________________________ 81
7.7.2 Command Set Categories ____________________________________________ 81
7.7.3 Initialization Control Commands _______________________________________ 81
7.7.4 ID Control Commands _______________________________________________ 81
7.7.5 Output Control Commands ___________________________________________ 82
7.8 Global Output Commands ___________________________________________________ 83
7.8.1 Description _______________________________________________________ 83
7.9 Fast Queries _____________________________________________________________ 84
7.9.1 Fast Test for Connection _____________________________________________ 85
7.9.2 Fast Read Registers ________________________________________________ 85
7.9.3 Read Power-On Time _______________________________________________ 86
7.9.4 Service Request Messages ___________________________________________ 86
7.10 Status Control Commands __________________________________________________ 86
7.11 Status, Error and SRQ Registers _____________________________________________ 87
7.11.1 General Description________________________________________________ 87
7.11.2 Conditional Registers ______________________________________________ 87
7.11.3 Conditional Registers (continued) _____________________________________ 88
7.11.4 Service Request: Enable and Event Registers ___________________________ 89
7.12 Serial Communication Test Set-Up ___________________________________________ 91
8 ISOLATED ANALOG PROGRAMMING OPTION __________________________________ 92
8.1 Introduction ______________________________________________________________ 92
8.2 Specifications _____________________________________________________________ 92
8.2.1 0-5V/0-10V OPTION (PN: IS510) _____________________________________ 92
8.2.2 4-20mA option (PN: IS420) __________________________________________ 92
8.3 Isolated Programming & Monitoring Connector ___________________________________ 93
8.4 Setup and Operating Instructions ______________________________________________ 93
8.4.1 Setting up the Power Supply for 0-5V/0-10V Isolated Programming/Monitoring ___ 94
8.4.2 Setting up the power supply for 4-20mA Isolated Programming and Monitoring ___ 94
9 MAINTENANCE ____________________________________________________________ 95
9.1 Introduction ______________________________________________________________ 95
9.2 Units Under Warranty _______________________________________________________ 95
9.3 Periodic Maintenance _______________________________________________________ 95
9.4 Adjustments and Calibration _________________________________________________ 95