5 - Putting into Operation
Installing the Te-Stack
Te-Stack Operating Manual, 391862, en, V2.3 5 - 1
5 Putting into Operation
Purpose of This
Chapter
This chapter describes how the Te-Stack is installed and gives instructions on
initial operation.
5.1 Installing the Te-Stack
ATTENTION
Damage to the system is possible, if installation has been carried out improperly.
The initial installation of the Te-Stack on the instrument must be carried out by
a Tecan FSE.
If the position of the Te-Stack should be altered, please call a Tecan FSE.
Where to place
the Te-Stack
Take the following considerations into account when deciding on where to place
the Te-Stack:
The placement of the Te-Stack depends on the overall configuration of the
instrument. Therefore, the position of the Te-Stack must be evaluated individually.
Note: If you need support in doing this, please contact your nearest Tecan
representative.
To Next Page
Loading...
