tecan Te-Stack 10612253 - Maintenance Schedule

7 - 2 Te-Stack Operating Manual, 391862, en, V2.3
7 - Preventive Maintenance
Maintenance Schedule
7.2 Maintenance Schedule
Maintenance
Record
Note: In order to be able to track all maintenance performed on the Te-Stack over
the whole lifetime, the periodic maintenance must be recorded as follows:
• Fill in the necessary data in the logbook of the superior instrument.
Every Day
Monthly
Maintenance
Tab. 7-1 Daily maintenance (all versions)
Instrument/Component Maintenance Task Reference
General Clean the complete Te-Stack.
Water with mild detergent
Tab. 7-2 Monthly maintenance (all versions)
Instrument/Component Maintenance Task Reference
Range Test Perform the Range Test. Refer to chapter
7.4 “Performing the Requested
Tests and Settings”,  7-4.
Mechanical Burn-in /
Validation Test
Perform the Mechanical Burn-in /
Validation test
Refer to chapter
7.4 “Performing the Requested
Tests and Settings”,  7-4.
Tab. 7-3 Monthly maintenance (Te-MO version)
Instrument/Component Maintenance Task Reference
Te-Stack Functional
Test
Perform the Te-Stack Functional
Test procedure.
Refer to chapter
7.4 “Performing the Requested
Tests and Settings”,  7-4.
Tab. 7-4 Monthly maintenance (Freedom EVO version)
Instrument/Component Maintenance Task Reference
System Test If each Transfer Station is
equipped with 2 Te-Stack base
units, perform the System Test
procedure.
Refer to chapter
7.4 “Performing the Requested
Tests and Settings”,  7-4.
Transfer Station
Functional Test
If each Transfer Station is
equipped with 4 Te-Stack base
units, perform the Transfer
Station Functional Test.
Refer to chapter
7.4 “Performing the Requested
Tests and Settings”,  7-4.
Barcode scanner
(option)
Clean laser beam output window Refer to chapter 7.3.4 “Barcode
Scanner”,  7-4.