tecan Te-Stack 10612253 - Stopping and Terminating a Run; Stopping a Run; Checking and Terminating Tasks after Stopping a Run; Switching the System off

6 - Operation
Stopping and Terminating a Run
Te-Stack Operating Manual, 391862, en, V2.3 6 - 7
6.6 Stopping and Terminating a Run
6.6.1 Stopping a Run
Note: Normally, the run is stopped automatically when finished.
6.6.2 Checking and Terminating Tasks after Stopping a Run
Note: The Te-Stack is always used together with other instruments. Refer to the
corresponding manuals as well.
1 Check, if the run has been terminated without any error (check for error
messages).
6.7 Switching the System Off
6.7.1 Checking Before Switching Off the System
Note: The Te-Stack is always used together with other instruments. Refer to the
corresponding manuals as well.
1 Make sure that the last run was terminated without errors (check for error
messages).
6.7.2 Switching Freedom EVO Off
1 Quit the application software.
2 Press the power on/off switch of Freedom EVO to shut down Freedom EVO.
ATTENTION
After switching Freedom EVO off, wait until the green light is dark (approx. 10 s)
before switching the instrument on again.
WARNING
Danger of contamination
Depending on the applications, parts of the unit may have been in contact with bio
hazardous, poisonous or even radioactive materials.
Make sure to treat these materials according to the applicable safety standards
and regulations.