Page 9.3
9.2. SERVICE MENU CONFIG.: VISIO - VISIOWEB
The procedure is activated by pressing the top right-hand corner, the bottom left-hand corner and
the bottom right-hand corner of the screen in that sequence, in Stand-By, as shown in the figure
below:
A new display will appear from which you can gain access to the various configuration menus, by
entering the password on the number keyboard:
Enter the password 2501 and press the ENTER key to confirm or EXIT to quit.
A menu will then appear which will provide access to the following sub-menus:
For the following menu, please refer to the relevant chapter in the VISIO manual.
To Next Page
Loading...
