CROSS PERSONAL: Service & maintenance manual - rev. 1.1
Page 7.14
7.14. DISMANTLING THE BRAKE BELT
Dismantling the Brake
Belt
On the right-hand side of the equipment
1. Disconnect the platform lever from the crank (see “Platform
Lever” dismantling procedure).
2. Remove the crank guard cover.
3. Unscrew the 2 screws anchoring the round "mirror-finish" guard
to the frame, using a 4 mm hex key.
4.
Using a tape measure, take the reference measurement for the
position of the screw of the belt tensioner, and then use it to
readjust the belt tension during reassembly.
5. Slacken the belt tension.
NOTE:
during reassembly, perform the “Belt tension
adjustment” procedure.
6. Mark the position of the timing lever on the frame.
7. Unscrew the screw anchoring the shaping lever, using a 5 mm
hex key and a 13 mm spanner.
NOTE: during reassembly, perform the “Mechanics/Crank
assembling shaping procedure”.
To Next Page
Loading...
