Technogym RUN 600 XTPRO - CONFIGURING THE MACHINE; USER SETTING PARAMETERS

RUN 600 XTPRO: Service & Maintenance Manual - rev. 1.3
Page 9.1
9. CONFIGURING THE MACHINE
9.1. USER SETTING PARAMETERS
To change the settings of the machine, when the equipment is in the standby mode, press numeric
keys 314 at the same time. The following will appear on the LED matrix:
PASSWORD = 0
Now, use the numeric keys to enter 2406 (the password) and press ENTER to confirm. At this
point, the setting procedure will show on the LED matrix the actual settings.
9.1.1. LANGUAGE USED
When a language is chosen from the list of languages available, all the messages on the display are
automatically shown in the chosen language. To change the current setting, when the language
actually in use will scroll on the LED matrix, press the proper numeric key (from 1 to 6) to choose
the desired language, as for the following table:
• EPROM I-D-GB
KEY LANGUAGE
1 ITALIAN
2 DEUTSCH
3 UK ENGLISH
• EPROM USA-F-NL
KEY LANGUAGE
1 USA ENGLISH
2 FRANCAIS
3 NEDERLANDS
• EPROM USA-J
KEY LANGUAGE
1 USA ENGLISH
2 JAPANESE
• EPROM E-P
KEY LANGUAGE
1 SPANISH
2 PORTUGUESE
and press ENTER to confirm your choice.