Technogym RUN 600 XTPRO - Disassembling the Elevation Motor Brushes

RUN 600 XTPRO: Service & Maintenance Manual - rev. 1.3
Page 7.29
7.18. DISASSEMBLING THE ELEVATION MOTOR BRUSHES
Figure 7.18-1
Carry out the procedures described in paragraphs
7.9. “Disassembling the motor guard” and 7.10.
“Disassembling the front plate”.
1. Manually, or using a small flat-head
screwdriver, unscrew the protective caps a of
the brushes.
2. Remove the BRUSHES b.
To reassemble the BRUSHES, carry out the
above steps in reverse order.