Technogym RUN 600 XTPRO - DISPLAYED ELEVATION IS INCORRECT

RUN 600 XTPRO: Service & Maintenance Manual - rev. 1.3
Page 6.36
6.10. THE DISPLAYED ELEVATION IS INCORRECT
The machine displays this error if there is a mismatch between the photocell model and the SW of
the elevation board or there is a bad photocell reading due to incorrect calibration, breakage or
disturbances produced by the motor brushes as a result of excessively high currents.
THE DISPLAYED
ELEVATION IS INCORRECT
Is the position of the limit switch
correct?
Is the elevation motor current
correct?
YES
NO
YES
Lubricate the elevation
bars
2
NO
Adjust limit switch
position
Is the photocell clean?
Clean the photocell
YES
Replace the photocell and
cable connecting the
elevation board and the
photocell
NO
Are the elevation bars lubricated?
NO
Replace the elevation
motor
YES
Is the SW of the elevation board
matching the photocell model?
NO
Install the proper version
YES
1