Technogym RUN 600 XTPRO - Minutes of Use of the Evelation Motor

RUN 600 XTPRO: Service & Maintenance Manual - rev. 1.3
Page 9.6
input the desired value using the numeric keys to enter and press ENTER to confirm. Just press
ENTER to maintain the original value.
9.4.3. MINUTES OF USE OF THE EVELATION MOTOR
To change this value, when the value actually in memory will scroll on the LED matrix:
MIN. UP/DOWN = xxx
input the desired value using the numeric keys to enter and press ENTER to confirm. Just press
ENTER to maintain the original value.
9.4.4. DISTANCE COVERED
To change this value, when the value actually in memory will scroll on the LED matrix:
KM DONE = xxx
input the desired value using the numeric keys to enter and press ENTER to confirm. Just press
ENTER to maintain the original value.
The system will now go back to the standby mode. The “CLEAR” key can be pressed at any time to
interrupt the setup procedure and return the equipment to the standby mode.