Technogym RUN 600 XTPRO - Checking the Operation of the Hand Sensor Receiver

RUN 600 XTPRO: Service & Maintenance Manual - rev. 1.3
Page 10.6
3. If the machine is equipped with a coded receiver (PCD technology), put on the coded strap and
wait for the machine to display the measured heart rate. At this point, using a heart rate
frequency simulator, check that the machine does not detect its presence and doesn’t alter the
previously measured heart rate.
10.3.13. CHECKING THE OPERATION OF THE HAND SENSOR RECEIVER
1. Using a separate heart rate meter, check that, when the sensors are gripped, both the machine
and the separate meter read out the same frequency, and that when the sensors are released the
machine does not detect any signal.