Technogym RUN 600 XTPRO - Measurement System; Maximum Time; Keys; Disabling the Function Keys

RUN 600 XTPRO: Service & Maintenance Manual - rev. 1.3
Page 9.2
9.1.2. MEASUREMENT SYSTEM
Either the EUROPEAN (Kg and Km) or the AMERICAN (pounds and miles) measurement system
can be chosen. To change the current setting, when the measurement system is actually in use will
scroll on the LED matrix, press the proper numeric key (1 or 2) to choose the desired measurement
system, as for the following table:
KEY MEASUREMENT SYSTEM
1 EUR = EUROPEAN
2 USA = AMERICAN
and press ENTER to confirm your choice.
9.1.3. MAXIMUM TIME
You can set the maximum time that can be programmed for each exercise. To change the current
setting, when the maximum time is actually in use will scroll on the LED matrix:
MAX TIME = xxx
input the desired time using the numeric keys and press ENTER to confirm.
9.1.4. ACTIVATING THE “+” AND “−
−−
−” KEYS
The user can enable the “+” and “−” keys to modify the target heart rate during exercise sessions in
CPR mode. To change the current setting, when the setting is actually in use will scroll on the LED
matrix:
+/- KEYS / CPR = xxx
press the proper numeric key (1 or 2) to choose the desired setting, as for the following table:
KEY
“+” AND “−
−−
−” KEYS
1 OFF = DISABLED
2 ON = ENABLED
and press ENTER to confirm your choice.
9.1.5. DISABLING THE FUNCTION KEYS
The function keys can be disabled so that exercise sessions can be started only using the TGS
portable memory. To change the current setting, when the setting is actually in use will scroll on the
LED matrix:
FUNCTION KEYS = xxx
press the proper numeric key (1 or 2) to choose the desired setting, as for the following table:
KEY FUNCTION KEYS
1 OFF = DISABLED
2 ON = ENABLED