4.9.6 Activate Pattern Function
the No. blank, and click pattern button.
4.9.7 Auto Scan Setup
er button. The interface is shown as in Figure 4-28.
In Figure 4-34, input mode value in
In Figure 4-33, click bord
Please go to Figure 4-30, use direction arrows to select camera left limit
Then please go to Figure 4-38 and click left limit button
Repeat the above procedures to set right limit.
Figure 4-38
4.9.8 Activate Auto Scan
can” button, the system begins auto scan.
op button to
4.10 Flip
34, click page switch button, you can see an interface is shown as below.
igure 4-30.
In Figure 4-
34, click “Auto S
Correspondingly, the auto scan button becomes to stop button. Click st
terminate scan operation.
In Figure 4-
See Figure 4-39. Here you can set a
uxiliary function.
Click page switch button again, system goes back to F
Figure 4-39
56
To Next Page
Loading...