TECO F510 series - Group 10: PID Parameters

4-39
Group 09: Communication Parameters
Code Parameter Name Setting Range Default Unit
Control Mode
Attribute
V/F SLV
PM
SLV
09-07 Fault Stop Selection
0: Deceleration to Stop Based on
Deceleration Time 1 when
Communication Fault Occurs.
3 - O O O
1: Coast to Stop when
Communication Fault Occurs.
2: Deceleration to Stop Based on
Deceleration Time 2 when
Communication Fault Occurs.
3: Keep Operating when
Communication Fault Occurs.
4. Run the Frequency Command
given by AI2
09-08 Comm. Fault Tolerance Count 1~20 1 - O O O
09-09 Waiting Time 5~65 5 ms O O O
09-10 Device Instance Number 1 ~ 254 1 - O O O
Note: Parameters in group 09 are not affected by parameter 13-08 (initialization).
Group 10: PID Parameters
Code Parameter Name Setting Range Default Unit
Control Mode
Attribute
V/F SLV
PM
SLV
10-00
PID Target Value Source
Setting
0: PUMP or HVAC function given
(refer to group 23)
1 - O O O
1: AI1 Given
2: AI2 Given
3: Reserved
4: 10-02 Given
5: Reserved
Note
6: Frequency Command (00-05)
Note
7: Multi-speed Frequency
Command
Note4
10-01
PID Feedback Value Source
Setting
1: AI1 Given
2 - O O O
2: AI2 Given
3: Reserved
4: AI1 - AI2 Given
10-02 PID Target Value 0.0~100.0 0.0 % O O O
10-03 PID Control Mode
xxx0b: PID Disable
0000b - O O O
xxx1b: PID Enable
xx0xb: PID Positive Characteristic
xx1xb: PID Negative Characteristic
x0xxb: PID Error Value of D
Control
x1xxb: PID Feedback Value of D
Control
0xxxb: PID Output