TECO F510 series - Page 204

4-115
【32】: Communication Control Contacts
【33】: RTC
Timer 1
【34】: RTC Timer 2
【35】: RTC Timer 3
【36】: RTC Timer 4
【37】: Detection Output of PID Feedback Loss
【38】: Brake Release
【42】: Over-High Pressure
【43】: Over-Low Pressure
【44】: Loss of Pressure Detection
【45】: PID Sleep
【46】: Over-High Flow
【47】: Over-Low Flow
【48】: Shortage of Low Suction
【49】: Communication Error
【50】: Frequency Detection 3 (≧ 03-44+03-45)
【51】: Frequency Detection 4 (＜ 03-44)
【52】: Frequency Detection 5 (≧ 03-46+03-47)
【53】: Frequency Detection 6 (＜ 03-46)
【54】: Turn on short-circuit braking
【57】: Low Current Detection
【58】: Frequency Deceleration Detection
【59】: Overheat Detection
*1: The parameters are available when the I/O expansion card installed.
Default function Related parameter
During
Running
Fault signal
03-11
03-12
R1B
R1C
R2A
R2C
R1A
R3A
R3C
Zero
Speed
03-39
Figure 4.4.22 Multi-function digital output and related parameters
Table 4.4.6 Description of multi-function digital output
Value
Function
Description
Control Mode
Name LCD Display V/F SLV
PM
SLV
0 During Running Running ON: During running (Run Command is ON) O O O
1
Fault Contact
Output
Fault
ON: Fault contact output (except CF00 and
CF01 )
O O O
2
Frequency
Agree
Freq. Agree
ON: Frequency agree (frequency agree width
detection is set by 03-14 )
O O O
3
Setting
Frequency
Agree
Setting Freq
Agree
ON: Output frequency = allowed frequency
detection level (03-13) ± frequency
bandwidth (03-14)
O O O
4
Frequency
Detection 1
Freq. Detect 1 ON: Output frequency ≧ 03-13 + 03-14 O O O
5
Frequency
Detection 2
Freq. Detect 2 OFF: Output frequency ≧ 03-13 + 03-14 O O O