Tegam 3550 - Data Output Format for Measurement Settings

5-15
3550 LCR Meter Instruction Manual Programming and Interfacing
RS-232C
Data Output Format for Measurement Settings
Output Format Sample
0000 _ P1 _ 1.00 E03 Hz _ OV _ +1.0795 E00 V _ +1.0771 E-03 A,
1 2 3 4 5 6 7 8 9 10 11 12
N R P _+1.0022 E03 R, GO, N _ A0 _ -1.1874 E03 R, GO, BIN1, GO
13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28
1 Indexing Number 15 Circuit Mode
There is no circuit mode on Z and
Y, alternatively, "-" is outputted.
2 Panel Number 16 Data Temp. Value (A)
3 Measurement Frequency Temp. Value 17 Data Exponent (A)
4 Measurement Frequency Exponent 18 Data Unit (A)
5 Measurement Frequency Unit 19 Comparator Result (A)
6 Measurement Mode 20 Status (B)
7 Test Piece Voltage Temp. Value 21 Function (B)
8 Test Piece Voltage Exponent 22 Data Temp. Value (B)
9 Test Piece Voltage Unit 23 Data Exponent (B)
10 Test Piece Current Temp. Value 24 Data Unit (B)
11 Test Piece Current Exponent 25 Comparator Result (B)
12 Test Piece Current Unit 26 Bin Number
13 Status (A) 27 Comparator Result (TOTAL)
14 Function (A) 28 Delimiter
NOTES:
For the Comparator Result, if the Comparator is OFF, 2 "_" symbols (ASCII Code 5Fh)
will be outputted instead of a result.
For the Bin No., if the Comparator is OFF, 4 "_" symbols (ASCII Code 5Fh) will be
outputted.
In the Format Sample, the "_” denotes a "space" (ASCII code 20h).