Menus
SET LOCAL TIME submenu
To access this m
enu, select SET LOCAL TIME in the INTERNAL CLOCK menu
and press the ENTER button. Use this menu to set the local time and date of the
instrument and to configure the local time zone offset. Use the up (▲)anddown
(▼) arrow buttons to scroll through the menu selections.
Figure 26: SET LOCAL TIME submenu
NOTE. The DST offset and the Timezone offset settings must be set prior to setting
the local time and date. This order of operation is necessary to correctly es tablish
the internal UTC and local time.
The instrument time is set correctly when the instrument is shipped from the
factory. After y ou configure the DST and Timezone offset settings for your
loc
ation, the local time should be very close to correct.
SET LOCAL TIME. Select this menu item to v iew and edit the internal time of the
in
strument. Press the ENTER button to edit the local time. Use the left (◄)or
right (►) arrow button to select one of the time digits, and then use the up (▲)or
down (▼) arrow button to edit the selected time digit. Press the ENTER button to
implement the new local time.
SET LOCAL DATE. Select this menu item to view and edit the internal d ate of the
instrument. Press the ENTER button to edit the local date. Use the left (◄)or
right (►) arrow button to select one of the date digits, and then use the up (▲)or
down (▼) arrow button to edit the selected date digit. Press the ENTER button to
implement the new local date.
80 ECO8000 Series Automatic Changeover Unit User Manual
To Next Page
Loading...
Need help?
General
