Tektronix ECO8000 Series User Manual

Getting Started
Figure 1: Installing or removing the instrument into or from the rack
To remove the instrument from an equipment rack. Perform the following steps to
remove an instrument that is installed in an equipment rack:
WARNING. To prevent injury when removing the product from the rack, do not
forcefully and abruptly pull the product from the rack. Pull with the minimum
forc
erequiredtomovetheinstrumentwith a consistent, even motion.
1. Loosen the knob screws, if present, that attach the front of the instrument
to t
he rack.
2. Gently pull the instrument toward you until you can reach the levers at the
re
ar of the instrument.
3. Tilt both lever handles upward simultaneously to allow them to clear the
s
tops. (See Figure 1.)
4. Pull the instrument past the stops and out of the rack.
ECO8000 Series Automatic Changeover Unit User Manual 5

Tektronix ECO8000 Series Specifications

General

Brand	Tektronix
Model	ECO8000 Series
Category	Control Unit
Language	English