Remote control
Operational
considerations
When you operat
e the Web Interface, be aware of the following operational
considerations:
CAUTION. If the SNMP community strings are changed from the factory-default
values of “public” and “private” to some other user-defined strings, the Web
Interface will not operate.
It is recommended that a maximum of four simultaneous users be connected to the
instrument using the Web Interface. If more users are connected, it may result in
lower performance and inconsistent behavior.
Some front panel operations may interrupt or reduce the performance of the Web
Interface. For example, the Web server may experienc e temporary delays when
many butt
ons are being pressed on the front panel.
Levels of control. Use the SYSTEM CONFIG menu to confi gure the level of
instrument control that is available from the Web Interface. The following levels
of control are available:
Full control: All settings can be changed.
Read only: Settings can be viewed but not c hanged.
Disabled: No instrument access allowed by a Web browser.
Supported Web browsers. For best results, use Google Chrome, Mozilla Firefox,
Safari, or Internet Explorer 9.0 or later when you connect to the ECO8000 Series
Web Interface.
NOT
E. The Web Interface requires Javascript to run.
Ease of use. Most instrument controls and views are e asier to access and
co
nfigure using the Web Interface. Examples of where this is especially true are:
Viewing instrument status
Viewing the Event Log
Viewing diagnostic results
Configuring event reporting
Configuring e-mail reporting
Configuring channel settings such as threshold levels, labels, etc.
96 ECO8000 Series Automatic Changeover Unit User Manual
To Next Page
Loading...
Need help?
General
