Remote control
Table 23: SNMP parameters (cont.)
Trap Destination 1 to 4
Use this setting to set the IP addresses to which SNMP traps are
sent through SNMP. Traps can be sent to up to four addresses
when error conditions are detected.
NOTE. A value of all zeroes for the address will disable that
trap output.
Public Community Use this setting to set the Public Community string. This string
is effectively a password. Without this string, SNMP commands
cannot read values from the instrument.
CAUTION. The Public String is necessary for SNMP access
to read values from the instrument. If the public or private
community strings are changed from their default values, the
Web Interface will not operate.
Private Community Use this setting to set the Private Community string. This string
is effectively a password. Without this string, SNMP commands
cannot change values in the instrument.
CAUTION. The Public String is necessary for SNMP access
to read values from the instrument. If the public or private
community strings are changed from their default values, the
Web Interface will not operate.
Downloading the MIB
You can download the ECO8000 Series MIB file using the of the System tab
on the ECO8000 Series Web Interface.
In the SNMP and Network Configuration section, click Download ECO MIB
File to download the file to your computer. You can use a text file editor such
asWordpadtoviewthefile contents.
100 ECO8000 Series Automatic Changeover Unit User Manual
To Next Page
Loading...
Need help?
General
