4200A-SCS Parameter Analyzer User's Manual Section 2: Getting started
4200A-900-01 Rev. D/April 2020 2-9
Connecting a LAN cable
The two LAN connectors on the 4200A-SCS are standard RJ-45 connectors intended for use with
unshielded twisted pair (UTP) cable. For best results, use only CAT 5 UTP cables equipped with
RJ-45 connectors to connect your LANs, as shown in the following figure.
If IP addresses are statically assigned, you need to assign a different IP address to each LAN port.
Figure 5: LAN connections
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
