Section 2: Getting started 4200A-SCS Parameter Analyzer User's Manual
2-10 4200A-900-01 Rev. D/April 2020
Connecting GPIB instruments
You can use the 4200A-SCS to control one or more external instruments using the IEEE-488 general
purpose instrument bus (GPIB). An example of typical instruments used in a test system with the
4200A-SCS are a switching system and an external C-V meter.
The following figure shows how to connect GPIB instruments to the 4200A-SCS.
Figure 6: 4200A-SCS GPIB instrument connections
Connecting the interlock
The next figure shows the location of the interlock connector on the rear panel of the 4200A-SCS.
To connect the interlock:
1. Connect one end of the supplied 236-ILC-3 interlock cable to the interlock connector on the rear
panel of the 4200A-SCS (see the next figure).
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
