Tektronix MSO3000 Series - Page 54

Get Acquainted w
ith the Instrument
8. Save / Recall Menu. P ush to save and
recall setups, waveforms, and screen
images to inte
rnal memory or a USB
flash drive.
9. Channel 1,2,3,or4Menu. Push
to set vertical parameters for input
waveforms a
nd to display or remove
the corresponding waveform from the
display.
10. B1 or B2. Pushtodefine and display a
bus if you have the appropriate module
application keys.
The DPO3AERO module supports
MIL-STD-1553 buses.
The DPO3AUTO module supports CAN
and LIN buses.
The DPO3E MBD module supports I
2
C
and SPI.
The D PO3FLEX module supports
FlexRay buses.
The DPO3COMP module supports
RS-232, RS-422, RS-485, and UART
buses.
The DPO3AUDIO module supports I
2
S,
Left Justi fi ed (LJ), Right Justified (RJ),
and TDM buses.
Also, push B1 or B2 to display or remove
the corresponding bus from the display.
11. R. Push to manage reference waveforms,
including the display or removal of each
reference waveform from the display.
12. M. Push to manage the math waveform,
including the display or removal of the
math waveform from the display.
Using Other Controls
T
hese buttons and knobs control waveforms, cursors, and other data input.
32 MSO3000 and DP O3000 Series Oscilloscopes User Manual