Removal and Installation Procedures
6·10
General Instructions
READ THESE GENERAL INSTRUCTIONS BEFORE REMOVING A
MODULE.
First read over the Summary
of
Procedures that follows to under-
stand how the procedures are grouped. Then read
Equipment
Required
for a list
of
the tools needed to remove and install modules
in
this oscilloscope.
Procedures refer to the "front," "rear," "top," etc.
of
the oscilloscope.
Figure
6-1
illustrates these references.
Figure 6·1: Oscilloscope Orientation
Summary of Procedures
The procedures are described
in
the order
in
which they appear
in
this
section.
In
addition, you can look up any procedure for removal and reinstal-
lation
of
any module in the Table
of
Contents of this manual.
Maintenance
•
•
•
To Next Page
Loading...
